LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 1085 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Propeller Shaft Front Slip Yoke Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Case Extension Housing Rear Oil Seal
    GM647512Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the inside diameter of the new seal with J 36850  .
  2. Use the J 21426  with a soft faced mallet to install the seal.
  3. Install the seal to the extension housing.
  4. Install the propeller shaft. Refer to One-Piece Propeller Shaft Replacement or Two-Piece Propeller Shaft Replacement .
  5. Remove the drain pan and lower the vehicle.
  6. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to Transmission Fluid Check .
scientia non olet · About LEMON Manuals