LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 1085 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Manual Shift Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Sliding Seal Remover Tool Over Selector Shaft
    GM659335Courtesy of GENERAL MOTORS CORP.
  1. Remove the park/neutral position (PNP) switch. Refer to Park/Neutral Position Switch Replacement .
  2. Ensure that the jackscrew for J 43911  is backed off and will not interfere with installation of the removal tool. See Special Tools . Slide the seal remover tool over the selector shaft (2) with the threaded end of the tool towards the seal.
  3. Rotate the removal tool so that the threads on the end of the tool engage the steel shell (1) of the seal. Use a wrench to ensure that the removal tool is firmly attached to the seal shell.
  4. Rotate the jackscrew in the clockwise direction to remove the seal from the bore. Discard the seal that was removed.
scientia non olet · About LEMON Manuals