1-2 Accumulator Installation: Installation

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Valve Body Bonded Spacer Plate

Courtesy of GENERAL MOTORS CORP.

Inspect the valve body bonded spacer plate for damage or debris.

Fig 2: Locating #1 Checkball

Courtesy of GENERAL MOTORS CORP.

Install the #1 checkball into the case.

Fig 3: Aligning Valve Body Bonded Spacer Plate

Courtesy of GENERAL MOTORS CORP.

Install the J 25025-5 into the case. See Special Tools .

IMPORTANT: Do not reuse the bonded spacer plate. Replace with a NEW bonded spacer plate.

Place the bonded spacer plate on the case.

Fig 4: View Of Spacer Plate Support Plate & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the spacer plate support plate (53 or 113).
Install the spacer plate support bolts (77).

NOTE: Refer to Fastener Notice .

Install the accumulator bolt (115), model dependent.
Tighten: Tighten the accumulator bolt to 11 N.m (8.11 lb ft).

Fig 5: View Of 1-2 Accumulator Housing And Bolts

Courtesy of GENERAL MOTORS CORP.

Install the 1-2 accumulator housing assembly (57 or 116).
Install the 1-2 accumulator housing bolts (58, 59 or 117, 118).
Tighten:
- Tighten the bolts 58 and 59 to 11 N.m (8 lb ft).
- Tighten the bolts 117 and 118 to 8-14 N.m (6-10 lb ft).