Clutch Slave Cylinder: Service and Repair

Clutch Concentric Actuator Cylinder Replacement (CTS)

Removal Procedure




1. Remove the transmission.
2. Remove the concentric actuator cylinder quick connect bolt (5).
3. Remove the 3 concentric actuator cylinder bolts (1).
4. Remove the concentric actuator cylinder (2).
5. Remove the O-ring (3).

Installation Procedure




1. Install the O-ring (3).
2. Install the concentric actuator cylinder (2).

Notice: Refer to Fastener Notice.

3. Install the 3 concentric actuator cylinder bolts (1) and the quick connect bolt (5).

* Tighten the 3 concentric actuator cylinder bolts to 20 N.m (15 lb ft).
* Tighten the quick connect bolt to 10 N.m (89 lb in).

4. Install the transmission.