Front Suspension

Stabilizer Shaft Link Replacement

Removal Procedure

Notice: The ball stud must not rotate during disassembly or reassembly. Hand tools must be used to keep the ball stud from rotating. If air tools are used and the stud is allowed to rotate, damage to the ball stud and/or stud mounting hole may occur.

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.




3. Disconnect the ABS sensor wiring harness from the stabilizer shaft link.




4. Remove the stabilizer shaft link retaining nuts.
5. Remove the stabilizer shaft link.

Installation Procedure





Important: Apply threadlocker 242 or equivalent to the threads of the stabilizer shaft link.

1. Install the stabilizer shaft link.

Notice: Refer to Fastener Notice.

2. Install the stabilizer shaft link retaining nuts.

Tighten the nuts to 50 N.m (37 lb ft).




3. Connect the ABS sensor wiring harness to the stabilizer shaft link.
4. Install the tire and wheel.
5. Lower the vehicle.