Fuel Injector Sight Shield Replacement

Fuel Injector Sight Shield Replacement

Removal Procedure




1. Remove the cross car brace, if necessary.
2. Remove the oil fill cap.
3. Disengage the cover/shield from the ball studs by pulling up firmly on the rear and front of the engine cover.
4. Remove the engine cover/sight shield.

Installation Procedure




1. Position the engine cover/sight shield over the intake manifold so the grommets are aligned with the ball studs.
2. Press the engine cover/sight shield down firmly near the ball studs in order to install the engine cover/sight shield.
3. Install the oil fill cap.
4. Install the cross car brace, if necessary.