Antenna, TV: Service and Repair

TV Antenna Module Replacement

Removal Procedure




1. Remove the rear shelf panel.
2. Disconnect the TV module electrical connector (1).




3. Disconnect the coax cables (3).




4. Remove the fasteners (1) securing the TV module (1) to the rear shelf.
5. Remove the TV module (2) from the rear shelf.

Installation Procedure




1. Install the TV module (1) to the rear shelf.

Notice: Refer to Fastener Notice.

2. Install the fasteners securing the TV module to the rear shelf.

Tighten the fasteners to 9 N.m (80 lb in).




3. Connect the coax cables (3) to the TV module.




4. Connect the electrical connector (1).
5. Reinstall the rear shelf.