Antenna Amplifier: Service and Repair

TV Antenna Amplifier Replacement

Removal Procedure




1. Remove the right rear sail panel.
2. Remove the fasteners (2) securing the amplifier (1) to the sail panel.
3. Disconnect the coaxial cable.
4. Disconnect the electrical connector.

Installation Procedure






Important: Ensure that the module coaxial cable connectors are pointing away from each other.

1. Reconnect the electrical connector.

Notice: Refer to Fastener Notice.

2. Install the amplifier (1) to the sail panel using the fasteners (2).

Tighten the fasteners to 9 N.m (80 lb in).

3. Connect the coaxial cable to the amplifier.
4. Reinstall the sail panel trim.