Rear Suspension

Stabilizer Shaft Link Replacement

Removal Procedure

Notice: The ball stud must not rotate during disassembly or reassembly. Hand tools must be used to keep the ball stud from rotating. If air tools are used and the stud is allowed to rotate, damage to the ball stud and/or stud mounting hole may occur.

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.




3. Remove the stabilizer shaft link retaining nuts.
4. Remove the stabilizer shaft link from the stabilizer shaft.
5. Remove the stabilizer shaft link from the lower control arm.

Installation Procedure




1. Install the stabilizer shaft link to the lower control arm.
2. Install the stabilizer shaft link to the stabilizer shaft.

Notice: Refer to Fastener Notice.

3. Install the stabilizer shaft link retaining nuts.

Tighten the nuts to 50 N.m (37 lb ft).

4. Install the tire and wheel.
5. Lower the vehicle.