Roll Rate Sensor: Testing and Inspection

Inflatable Restraint Sensing and Diagnostic Module Programming and Setup

Important: The air bag indicator light may remain ON after the dash integration module (DIM) or sensing and diagnostic module (SDM) is replaced, and during the programming procedure for the DIM, until after the procedure is completed and the ignition key is cycled OFF and ON.

If the SDM is replaced, perform the learning the restraints ID procedure for the DIM. Refer to Body Control Module (BCM) Programming/RPO Configuration (DIM) Body Control Module (BCM) Programming/RPO Configuration (RIM) for learning the restraints ID procedure.