Blower Motor Replacement (RHD)

Blower Motor Replacement (RHD)

Removal Procedure

1. Remove the left closeout insulator panel.
2. Remove the IP compartment.




3. Disconnect the electrical connector (1).




4. Remove the blower motor screws (1).




5. Remove the blower motor.

Installation Procedure




1. Install the blower motor.






Notice: Refer to Fastener Notice.

2. Install the blower motor screws (1).

Tighten the screws to 1.5 N.m (13 lb in).

3. Connect the blower motor electrical connector (1).




4. Install the IP compartment.
5. Install the left closeout insulator panel.