LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> CTS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 598 (Automatic Transmission - 6L50/6L80 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Pipe Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the TOC lines.
  2. CAUTION: Refer to Fastener Caution .
  3. Install the TOC retainer bracket bolt and tighten to 16 N.m (12 lb ft).
  4. Fig 1: View of TOC Line To Transmission Retainer Bolt
    GM1710028Courtesy of GENERAL MOTORS CORP.
  5. Install new O-rings to the rear TOC lines.
  6. Connect the rear TOC lines to the transmission.
  7. Install the rear TOC line to transmission retainer bolt and tighten to 25 N.m (18 lb ft).
  8. Connect the rear TOC line to the front TOC line.
  9. Connect the rear TOC line to the radiator.
  10. Install drivetrain and front suspension frame. Refer to DRIVETRAIN AND FRONT SUSPENSION FRAME REPLACEMENT
  11. Install the LH front splash shield.
  12. Install the LH front splash shield retainers.
  13. Install the LH front wheel. Refer to Tire and Wheel Removal and Installation .