LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> CTS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 598 (Automatic Transmission - 6L50/6L80 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Shift Control Linkage Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Manual Shift Shaft Nut
    GM1827761Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control linkage to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the manual shift shaft nut and tighten to 20 N.m (15 lb ft).
    3. Fig 2: View Of Shift Control Linkage Rod
    GM1827759Courtesy of GENERAL MOTORS CORP.
  3. Connect the shift control linkage rod to the shift control assembly.
  4. Install the nut to the shift control linkage rod.
  5. Adjust the shift control linkage. Refer to Shift Control Linkage Adjustment (All Wheel Drive)  or Shift Control Linkage Adjustment (Rear Wheel Drive) .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals