LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> CTS V >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Primary Latch Release Cable Replacement >> Installation Procedure

Installation Procedure

  1. Transfer the string to either end of the new hood release cable.
  2. Route the string and the hood release cable into the passenger compartment.
  3. Remove the string from the hood release cable.
  4. Seat the hood release cable grommet into the wheel opening.
    5. Fig 1: Identifying Hood Release Cable & Hood Release Handle
    GM714073Courtesy of GENERAL MOTORS CORP.
  5. Connect the hood release cable (2) to the hood release handle (1).
    6. NOTE: Refer to Fastener Notice .
    Fig 2: View Of Hood Release Handle & Fasteners
    GM714080Courtesy of GENERAL MOTORS CORP.
  6. Install the fasteners (3) in order to secure the hood release handle (1) to the vehicle.

    Tighten:  Tighten the fasteners to 2 N.m (18 lb in).

    7. Fig 3: Identifying Hood Release Cable Routing
    GM739453Courtesy of GENERAL MOTORS CORP.
  7. Pull the string and the hood release cable through the engine compartment.
  8. Remove the string from the hood release cable.
  9. Connect the hood release cable to the hood latch.
  10. Install the hood latch. Refer to Hood Latch Replacement .
  11. Close the hood.
scientia non olet · About LEMON Manuals