LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> CTS V >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Fender Replacement - Front >> Installation Procedure

Installation Procedure

    Fig 1: Removing & Installing Bolts Securing Upper Portion To Vehicle
    GM791899Courtesy of GENERAL MOTORS CORP.
  1. Position the front fender to the vehicle.
    2. NOTE: Refer to Fastener Notice.
  2. Install the bolts (1) in order to secure the upper portion of the front fender to the vehicle.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  3. Install the bolt (2) in order to secure the rear portion of the front fender to the vehicle.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

    4. Fig 2: Removing & Installing Bolts Securing Lower Rear Portion To Vehicle
    GM895004Courtesy of GENERAL MOTORS CORP.
  4. Install the bolts (1) in order to secure the lower rear portion of the front fender to the vehicle.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    5. Fig 3: Removing & Installing Bolts Securing Lower Front Portion To Vehicle
    GM894342Courtesy of GENERAL MOTORS CORP.
  5. Install the bolts (1) in order to secure the lower front portion of the front fender to the vehicle.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  6. Install the hood. Refer to Hood Replacement .
  7. Install the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  8. Install the rocker panel molding. Refer to Rocker Panel Molding Replacement .
  9. Install the headlamp. Refer to Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement .
  10. Remove the tape from the corners of the panels and adjacent surfaces.
scientia non olet · About LEMON Manuals