Trunk Ajar Indicator Always On

Step	Action	Yes	No
Schematic Reference: Release Systems Schematics or Instrument Cluster Schematics Connector End View Reference: Vehicle Access Connector End Views or Displays and Gages Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Close the rear compartment. Is the trunk ajar indicator illuminated/message displayed?	Go to Step 3	Go to Testing for Intermittent Conditions and Poor Connections
3	Install a scan tool. Turn ON the ignition with the engine OFF. Close the rear compartment. With a scan tool observe the rear compartment lid ajar switch signal input in the rear integration module (RIM) data list. Does the scan tool indicate the rear compartment is open?	Go to Step 4	Go to Step 7
4	Disconnect the rear compartment lid release actuator. Is the trunk ajar indicator illuminated/message displayed?	Go to Step 5	Go to Step 6
5	Inspect for a short to ground in the rear compartment lid ajar switch signal circuit. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 10	Go to Step 9
6	Inspect for poor connections at the harness connector of the rear compartment lid release activator. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 10	Go to Step 8
7	Replace the driver information center (DIC). Refer to Control Module References for replacement, setup, and programming. Did you complete the repair?	Go to Step 10	-
8	Replace the rear compartment lid release actuator. Refer to Rear Compartment Lid Switch Replacement . Did you complete the repair?	Go to Step 10	-
9	Replace the RIM. Refer to Control Module References for replacement, setup, and programming. Did you replace the repair?	Go to Step 10	-
10	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3