LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> XLR Base >> Repair and Diagnosis >> Electrical >> Instrument Panel System Displays, Gauges And Console >> Diagnostic Information and Procedures >> Scan Tool Data List

Scan Tool Data List

The scan tool data lists contain all the instrument panel, gage, and console related parameters that are available on the scan tool. The parameters in the list are arranged in alphabetical order. The data list column indicates the location of the parameter within the scan tool menu selections.

Use the scan tool data lists as directed by a diagnostic table or in order to supplement the diagnostic procedures. Begin all of the diagnostic procedures with Diagnostic System Check - Vehicle in Vehicle DTC Information.

Use the scan tool data lists only after the following is determined:

The typical data values are obtained from a properly operating vehicle under the conditions specified in the first row of the scan tool data list table. Comparison of the parameter values from the suspect vehicle with the typical data values may reveal the source of the customer concern.

Engine Control Module (ECM) 4.6L

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Engine Idling/Normal Operating Temperature
Commanded Gear IPC Data Shift, 1st, 2nd, 3rd, 4th, 5th, Invalid, Invalid, Reverse, Neutral, or Park Park
Cruise Control Active IPC Data No/Yes No
ECT Sensor IPC Data Celsius (Fahrenheit) 85-105°C (185-220°F)
Engine Oil Life Remaining IPC Data 100-0 Percent (%) Varies w/oil life
Engine Oil Pressure Sensor IPC Data kPa (psi) Varies w/oil pressure
Engine Oil Pressure Sensor IPC Data Volts Varies w/oil pressure
Engine Oil Temperature Calculated IPC Data Celsius (Fahrenheit) Varies w/oil temperature
Engine Speed IPC Data RPM +/-100 RPM from Desired Idle Speed
Fuel Level Sensor- Left Tank IPC Data Volts Varies w/fuel level
Fuel Level Sensor- Right Tank IPC Data Volts Varies w/fuel level
Fuel Tank Level Remaining IPC Data Liters (Gallons) Varies w/fuel level
Ignition 1 Signal IPC Data Volts 9 - 16 V
MIL Circuit Status IPC Data Fault -
MIL Command IPC Data Off/On Off
Vehicle Speed Sensor IPC Data kilometers per hour (miles per hour) 0 km/h (0 mph)
Engine Control Module (ECM) 4.4L

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Engine Idling/Normal Operating Temperature
Change Engine Oil Indicator Command IPC Data Off/On Off
Cruise Control Active IPC Data No/Yes No
ECT Sensor IPC Data Celsius (Fahrenheit) 85-105°C (185-220°F)
Engine Oil Level Switch IPC Data Off/Ok Off
Engine Oil Life Remaining IPC Data 100-0 Percent (%) Varies w/oil life
Engine Oil Pressure Sensor IPC Data kPa (psi) Varies w/oil pressure
Engine Oil Pressure Sensor IPC Data Volts Varies w/oil pressure
Engine Oil Temperature Calculated IPC Data Celsius (Fahrenheit) Varies w/oil temperature
Engine Oil Temperature Sensor IPC Data Celsius (Fahrenheit) Varies w/oil temperature
Engine Speed IPC Data RPM +/-100 RPM from Desired Idle Speed
Engine Speed Circuit Status IPC Data Short Gnd/Open/Short to B+/Incomplete/Ok Ok
Fuel Level Sensor- Left Tank IPC Data Volts Varies w/fuel level
Fuel Level Sensor- Right Tank IPC Data Volts Varies w/fuel level
Fuel Tank Level Remaining IPC Data Liters (Gallons) Varies w/fuel level
Fuel Tank Level Remaining Fuel Tank Level Remaining 0-100 Percent (%) Varies w/fuel level
Ignition 1 Signal IPC Data Volts 9 - 16 V
Ignition Accessory Voltage IPC Data Off/On Off
Low EOP Indicator Command IPC Data Off/On Off
Low Engine Oil Level Indicator Command IPC Data Off/On Off
MIL Circuit Status IPC Data Fault -
MIL Command IPC Data Off/On Off
Vehicle Speed Circuit Status IPC Data Incomplete/Short to Gnd/Open/Short to B+/Ok Ok
Vehicle Speed Sensor IPC Data kilometers per hour (miles per hour) 0 km/h (0 mph)
Instrument Panel Cluster (IPC)

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Ignition ON/Engine OFF/Park Brake Unapplied
Chime IPC Data Off/On Off
Dim Down Switch IPC Data Inactive/Active Inactive
Dim Select Switch IPC Data Inactive/Active Inactive
Dim Up Switch IPC Data Inactive/Active Inactive
Engine Speed Signal IPC Data RPM +/-100 RPM from Desired Idle Speed
Information Down Switch IPC Data Inactive/Active Inactive
Information Up Switch IPC Data Inactive/Active Inactive
Options Switch IPC Data Inactive/Active Inactive
Odometer IPC Data Kilometers (Miles) Varies (0 - 99,999)
Reset Switch IPC Data Inactive/Active Inactive
Vehicle Speed Signal IPC Data kilometers per hour (miles per hour) 0 km/h (0 mph)
Head Up Display (HUD)

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Ignition ON/Engine OFF/Park Brake Unapplied
Adjust Display Down Switch IPC Data Inactive/Active Inactive
Adjust Display Up Switch IPC Data Inactive/Active Inactive
Battery Voltage Signal IPC Data Volts 9 - 16 V
Dimming Level IPC Data 0-100 Percent (%) Varies w/dimming level
English Metric Status IPC Data English/Metric English
Language IPC Data English, French, German, Italian, Spanish, or Japanese Varies w/selection
Page Switch IPC Data Inactive/Active Inactive