LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> XLR Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel Trim Pad Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of I/P Trim Pad & Screws
    GM1224695Courtesy of GENERAL MOTORS CORP.
  1. Align the I/P trim pad to the vehicle.
  2. Connect the sunload/twilight sensor to the trim pad.
  3. Align the trim pad retaining clips to the I/P panel carrier and push down to engage all of the clips.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the trim pad retaining screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  5. Install the I/P side trim panels.
  6. Install the windshield side garnish moldings. Refer to Windshield Side Garnish Molding Replacement .
  7. Install the dimmer/head-up display switch. Refer to Head Up Display Switch Replacement .
  8. Install the driver information center (DIC). Refer to Driver Information Display Switch Replacement .
  9. Install the driver side knee bolster. Refer to Driver Knee Bolster Panel Replacement .
  10. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
  11. Install the console trim plate. Refer to Console Trim Plate Replacement .
  12. Enable the SIR system. Refer to SIR Disabling and Enabling and to SIR Disabling and Enabling in SIR.
scientia non olet · About LEMON Manuals