Installation Procedure

Fig 1: View Of Lower Right Closeout Panel

Courtesy of GENERAL MOTORS CORP.

Install the right closeout panel under the dash.
Insert the I/P courtesy lamp down through the opening in the closeout panel.
Raise the closeout panel slightly, and carefully maneuver the left side of the closeout panel into position above the driveline tunnel.
Install the closeout panel push-in retainers to the I/P lower support beam.

Fig 2: View Of I/P Courtesy Lamp Assembly & Lower Closeout Panel

Courtesy of GENERAL MOTORS CORP.

Align the I/P courtesy lamp to the closeout panel opening, then push to secure the lamp in place.