Removal Procedure
- Disable the SIR system. Refer to the following procedures in SIR.
- Disconnect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Remove the console assembly. Refer to Console Replacement .
- Remove the radio. Refer to Radio Replacement in Entertainment.
- Remove the closeout/insulator panels. Refer to Instrument Panel Insulator Panel Replacement - Right Side and to Instrument Panel Insulator Panel Replacement - Left Side .
- Remove the instrument panel (I/P) compartment. Refer to Instrument Panel Compartment Replacement .
- Remove the I/P compartment trim bezel. Refer to Instrument Panel Compartment Trim Bezel Replacement .
- Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
- Remove the left knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement .
- Remove the right and the left I/P trim panels. Refer to Instrument Panel Trim Panel Replacement - Left Side and to Instrument Panel Trim Panel Replacement - Right Side .
- Remove the right and the left hinge pillar trim. Refer to Body Hinge Pillar Trim Panel Replacement in Interior Trim.
- Remove the windshield side garnish moldings. Refer to Windshield Side Garnish Molding Replacement in Interior Trim.
- Remove the right and the left I/P end caps. Pull outward to disengage the caps from the I/P.
- Remove the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement .
- Remove the I/P cluster (IPC). Refer to Instrument Cluster Replacement .
- Remove the speakers from the I/P. Refer to Radio Front Speaker Replacement in Entertainment.
- Remove the sensing and diagnostic module (SDM) and the YAW sensors from the I/P carrier.
- Remove the global positioning system (GPS) antenna from the I/P carrier. Refer to Global Positioning System (GPS) Antenna Replacement in Navigation Systems.
- Remove the remote control door lock receiver. Refer to Remote Control Door Lock Receiver Replacement in Keyless Entry.
- Remove the steering wheel from the steering column. Refer to Steering Wheel Replacement in Steering Wheel and Column.
- Remove the retaining bolts and nuts from the I/P carrier.
- Remove the retaining bolts from the lower beam behind the I/P compartment door.
- Remove the I/P compartment striker from the I/P carrier.
- Remove the I/P carrier from the mounting and slowly route all of the wiring from the I/P carrier.
- Remove the I/P carrier from the vehicle.
CAUTION:
Refer to SIR Caution
in Cautions and Notices.
CAUTION:
Refer to Battery Disconnect Caution
in Cautions and Notices.