LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> XLR Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel Carrier Replacement >> Installation Procedure

Installation Procedure

  1. Position the I/P carrier to the lower and the upper I/P beams.
  2. Route the I/P wiring harness.
  3. Fig 1: View Of I/P Carrier Retaining Bolts & Nuts
    GM1224723Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the retaining bolts and nuts to the I/P carrier.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  5. Fig 2: View Of I/P Compartment Striker & Screws
    GM1224690Courtesy of GENERAL MOTORS CORP.
  6. Install the I/P compartment striker.

    Tighten:  Tighten the striker to 1.9 N.m (17 lb in).

  7. Fig 3: View Of I/P Compartment
    GM1224684Courtesy of GENERAL MOTORS CORP.
  8. Install the I/P retaining bolt at the lower beam behind the I/P compartment door.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  9. Install the steering wheel to the steering column. Refer to Steering Wheel Replacement in Steering Wheel and Column.
  10. Install the remote control door lock receiver. Refer to Remote Control Door Lock Receiver Replacement in Keyless Entry.
  11. Install the GPS antenna to the I/P carrier. Refer to Global Positioning System (GPS) Antenna Replacement in Navigation Systems.
  12. Install the SDM and the YAW sensors to the I/P carrier.
  13. Install the speakers to the I/P. Refer to Radio Front Speaker Replacement in Entertainment.
  14. Install the I/P cluster (IPC). Refer to Instrument Cluster Replacement .
  15. Install the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement .
  16. Install the right and the left I/P end caps.
  17. Install the windshield side garnish moldings. Refer to Windshield Side Garnish Molding Replacement in Interior Trim.
  18. Install the right and the left hinge pillar trim. Refer to Body Hinge Pillar Trim Panel Replacement in Interior Trim.
  19. Install the right and the left I/P trim panels. Refer to Instrument Panel Trim Panel Replacement - Left Side  and to Instrument Panel Trim Panel Replacement - Right Side .
  20. Install the left knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement .
  21. Install the I/P compartment trim bezel. Refer to Instrument Panel Compartment Trim Bezel Replacement .
  22. Install the I/P compartment. Refer to Instrument Panel Compartment Replacement .
  23. Install the closeout/insulator panels. Refer to Instrument Panel Insulator Panel Replacement - Right Side  and to Instrument Panel Insulator Panel Replacement - Left Side .
  24. Install the radio. Refer to Radio Replacement in Entertainment.
  25. Install the console assembly. Refer to Console Replacement .
  26. CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  27. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  28. CAUTION: Refer to SIR Caution in Cautions and Notices.
  29. Enable the SIR system. Refer to the following procedures in SIR.