LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> XLR Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Cluster Head Up Display Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing HUD Assembly
    GM378935Courtesy of GENERAL MOTORS CORP.
  1. Transfer the retaining screw and nut to the replacement HUD.
  2. Install the HUD to the vehicle:
    1. Install the HUD onto the dash panel mounting studs.
    2. Slide the HUD retaining screw into the slot on the steering column bracket.
    3. NOTE: Refer to Fastener Notice .
  3. Install the HUD retaining nuts.

    Tighten:  Tighten the nuts to 5 N.m (44 lb in).

  4. Tighten the screw that retains the HUD to the steering column bracket.

    Tighten:  Tighten the screw to 3 N.m (27 lb in).

    5. Fig 2: View Of IPC & Screws
    GM1224708Courtesy of GENERAL MOTORS CORP.
  5. Install the retaining screws that secure the IPC to the steering column bracket.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

    6. Fig 3: Securing The HUD Electrical Harness Between The IPC And The HUD
    GM378944Courtesy of GENERAL MOTORS CORP.
  6. Connect the HUD electrical connector to the IPC.
  7. Carefully secure the HUD electrical harness (1) down between the IPC and the HUD as shown.
  8. Install the I/P carrier. Refer to Instrument Panel Carrier Replacement .
  9. Connect the negative battery cable.

    Tighten:  Tighten the cable bolt to 15 N.m (11 lb ft).

  10. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals