LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> XLR Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Driver Knee Bolster Panel Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Driver Knee Bolster Trim Panel & Screws
    GM1224656Courtesy of GENERAL MOTORS CORP.
  1. Insert the electrical connector for the fuel door and the rear compartment lid release switch through the opening in the trim panel.
  2. Install the driver knee bolster trim panel.
    3. NOTE: Refer to Fastener Notice .
  3. Install the remaining driver knee bolster trim panel retaining screw.

    Tighten:  Tighten the screws to 1.8 N.m (16 lb in).

  4. Install the fuel door and the rear compartment lid release switch.
    1. Connect the electrical connector to the switch.
    2. Align the switch, then push to secure the switch.
scientia non olet · About LEMON Manuals