Transmission Final Test and Inspection

WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Complete the following procedure after the transmission is installed in the vehicle:

With the ignition OFF or disconnected, crank the engine several times. Listen for any unusual noises or evidence that any parts are binding.
Start the engine and listen for abnormal conditions.
While the engine continues to idle, raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Inspect for fluid leaks while the engine is idling.
Perform a final inspection for the proper fluid level.
Lower the vehicle.
If a NEW TCM has been installed into the vehicle, the NEW module needs to be reprogrammed. Refer to SERVICE PROGRAMMING SYSTEM (SPS) .
NOTE:
The Service Fast Learn Adapts procedure must be performed when one of the following repairs have been made to the vehicle. Failure to perform the procedure after one of the following repairs may result in poor transmission performance, as well as transmission DTCs being set:
- Transmission internal service/overhaul
- Valve body repair or replacement
- Control solenoid valve assembly replacement
- TCM software/calibration update
- Any service in response to a shift quality concern
Perform the Reset Transmission Adapts. Refer to Reset Transmission Adapts .
Road test the vehicle.