LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 461 (Automatic Transmission - 6L50/6L80 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmission mount support assembly to the vehicle.
    2. Fig 1: View Of Transfer Case Mounting Bolts
    GM1850363Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE: The transmission mount bolts must be tightened in the proper order.
  2. Install by hand the transmission mount support to transfer case mounting bolts.
    1. Tighten the right side bolt to 110 N.m (81 lb ft).
    2. Tighten the left side bolt to 110 N.m (81 lb ft).
    3. Fig 2: View Of Body Mounting Bolts
    GM1850365Courtesy of GENERAL MOTORS CORP.
  3. Install the transmission mount support to body mounting bolts and tighten to 60 N.m (44 lb ft).
    4. Fig 3: View Of Retainers
    GM1850371Courtesy of GENERAL MOTORS CORP.
  4. Install the transmission vent hose to the retainers (6) on the mount assembly.
  5. Remove the transmission jack.
  6. Install the exhaust system.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals