Remote Control Door Lock and Theft Deterrent Receiver Replacement
Courtesy of GENERAL MOTORS CORP. Remote Control Door Lock and Theft Deterrent Receiver Replacement
| Callout |
Component Name |
| Door Lock Antenna Assembly Preliminary Procedure
- Remove the center console end cap. Refer to Center Console End Panel Replacement
in Instrument Panel, Gages, and Console.
- Disconnect the electrical connectors.
|
| 1 |
Antenna Assembly, Door Lock |
| Door Lock Ignition Key Antenna Assembly Preliminary Procedure
- Remove the center console. Refer to Front Floor Console Replacement
in Instrument Panel, Gages, and Console.
- Remove the console HVAC air duct.
|
| 2 |
Antenna Assembly, Ignition Lock Key |
| Door Lock Ignition Key Antenna Assembly Preliminary Procedure
- Remove the headliner. Refer to Headlining Trim Panel Replacement
in Interior Trim.
- Disconnect the electrical connectors.
|
| 3 |
Antenna Assembly, Ignition Lock Key |
| Door Lock Ignition Key Antenna Assembly Preliminary Procedure
- Remove the rear compartment sill trim. Refer to Rear Compartment Sill Trim Plate Replacement
in Body Rear End.
- Disconnect the electrical connectors.
|
| 4 |
Antenna Assembly, Ignition Lock Key |
| Remote Control Door Lock Receiver Preliminary Procedure
- Remove the rear compartment trim. Refer to Rear Compartment Trim Panel Replacement
in Body Rear End.
- Disconnect the electrical connectors.
- If replacing the receiver, program the receiver. Refer to Control Module References
in Computer/Integrating Systems.
|
| 5 |
Receiver Assembly, Remote Control Door Lock and Theft Deterrent |