Brake Switch - TCC: Service and Repair

Torque Converter Clutch/Cruise Control Release Switch Replacement

Removal Procedure
1. Remove the left closeout/insulator panel.





2. Remove the torque converter clutch/cruise release switch (3) by pulling the upper switch out of the retainer.
3. Disconnect the electrical connector from the torque converter clutch/cruise release switch (3).

Installation Procedure





1. Connect the electrical connector to the torque converter clutch/cruise release switch (3).
2. Install the torque converter clutch/cruise release switch (3) into the upper retainer.
3. Adjust the torque converter clutch/cruise release switch.
4. Install the left closeout/insulator panel.