Child Seat Tether Attachment: Service and Repair

CHILD RESTRAINT TETHER ANCHOR REPLACEMENT

REMOVAL PROCEDURE
1. Remove the rear shelf panel.

CAUTION: Do NOT attempt to repair or alter the bracket on the child seat restraint system. If the bracket is damaged, replace the entire bracket. Altering the bracket could result in personal injury.




2. Remove the bolt that retains the child tether anchor that is being serviced.
3. Remove the child tether anchor from the vehicle.

INSTALLATION PROCEDURE

IMPORTANT: During installation ensure that the child tether anchors are installed with the anti-rotation tabs firmly seated in the anti-rotation tab holes on the cross car beam.




1. Install the child tether anchor to the cross car beam.
2. Install the child tether anchor bolt.

NOTE: Refer to Fastener Notice.

Tighten the bolt to 30 N.m (22 lb ft).

3. Install the rear shelf trim panel.