Driver Knee Bolster Bracket Replacement

DRIVER KNEE BOLSTER BRACKET REPLACEMENT

REMOVAL PROCEDURE




1. Remove the instrument panel insulator.
2. Pull the bolster trim panel out and downward in order to release the clips securing the panel to the instrument panel.




3. Remove the bolts securing the bolster bracket to the instrument panel.

INSTALLATION PROCEDURE




1. Install the bolts securing the bolster bracket to the instrument panel.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolts to 9 N.m (80 lb in).




2. Locate the bolster trim panel onto the Instrument panel.
3. Push the trim panel in order to secure the clips to the instrument panel.
4. Install the insulator to the instrument panel.