Mode Actuator Replacement

MODE ACTUATOR REPLACEMENT

REMOVAL PROCEDURE
1. Remove the instrument panel (I/P) carrier.




2. Disconnect the mode actuator electrical connector.




3. Remove the mode actuator screws (3).




4. Remove the mode actuator.

INSTALLATION PROCEDURE




1. Install the mode actuator.




2. Install the mode actuator screws (2).

NOTE: Refer to Fastener Notice in Cations and Notices.

Tighten the screws to 1 N.m (9 lb in).




3. Connect the electrical connector to the actuator.
4. Install the I/P carrier.