TV Antenna Amplifier Replacement

TV ANTENNA AMPLIFIER REPLACEMENT

REMOVAL PROCEDURE




1. Remove the right rear sail panel.
2. Remove the fasteners (2) securing the amplifier (1) to the sail panel.
3. Disconnect the coaxial cable.
4. Disconnect the electrical connector.

INSTALLATION PROCEDURE




1. Reconnect the electrical connector.

IMPORTANT: Ensure that the module coaxial cable connectors are pointing away from each other.

2. Install the amplifier (1) to the sail panel using the fasteners (2).

Tighten the fasteners to 9 N.m (80 lb in).

NOTE: Refer to Fastener Notice.

3. Connect the coaxial cable to the amplifier.
4. Reinstall the sail panel trim.