Collision Avoidance and Parking Assist Systems: Service and Repair

INFORMATION CENTER TELLTALE ASSEMBLY REPLACEMENT

REMOVAL PROCEDURE
1. Remove the rear overhead console.




2. Remove screws securing the rear park assist tell tale module to the overhead console.
3. Disconnect the electrical connectors.

INSTALLATION PROCEDURE




1. Connect the electrical connectors.
2. Install the screws securing the rear park assist tell tale module to the overhead console.

Tighten the screws (1) to 2 N.m (18 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the rear overhead console.