Alarm Horn: Service and Repair

THEFT DETERRENT ALARM REPLACEMENT

REMOVAL PROCEDURE




1. Remove the right rear compartment trim.
2. Remove the nuts securing the theft deterrent alarm (1) to the vehicle body.
3. Disconnect the electrical connector (3) from the alarm.
4. Remove the alarm from the vehicle.

INSTALLATION PROCEDURE




1. Reconnect the electrical connector (3) to the alarm.
2. Install the alarm onto the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nuts to 9 N.m (80 lb in).

3. Install the rear compartment trim.