Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTCs P0068, P0101, P0102, P0103, P0112, P0113, P0116, P0117, P0118, P0125, P1101, P1258 are not set.
- The start-up ECT Sensor parameter is less than 42°C (107°F)
- The Intake Air Temperature Sensor parameter is less than -10°C (+14°F).
- The engine idle time is less than 95 percent.
- The fuel cut off time is less than 50 percent.
- The engine metal over temperature protection (EMOP) is not active.
- This diagnostic will run once in a 500 ms loop, and complete in a drive cycle.