Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0068, P0101, P0102, P0103, P0112, P0113, P0117, P0118 are not set.
The engine is running for more than 30 seconds.
The Intake Air Temperature Sensor parameter is more than -8.25°C (17°F).
The engine idle time is less than 50 percent.
The fuel cut-off time is less than 50 percent.
The engine metal over temperature protection (EMOP) is not active.
This diagnostic will run once and complete in a drive cycle.