New Special Tools Required

WARNING: This page is about a different variant/trim than selected.

There are new special tools required for 2006.

The crankshaft rear seal removal tool J 42841-A has been revised to fit both small or large engine flywheel bolt holes in the crankshaft.
The crankshaft rear seal installation tool J 45930-A has been revised to fit both small or large engine flywheel bolt holes in the crankshaft.
The valve retainer removing and installation tool J 43059 has been replaced by J-43059-A .
The piston pin clip remover and installation tool J 43654 has been replaced by EN-46745 .