LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 6L80E) >> Repair Instructions >> Vent Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Air Inlet Housing Front Panel
    GM1644927Courtesy of GENERAL MOTORS CORP.
  1. Remove the air inlet housing front panel (2). Refer to Air Inlet Housing Front Panel Replacement .
    2. Fig 2: Vent Hose Retainer
    GM1645250Courtesy of GENERAL MOTORS CORP.
  2. Remove the vent hose from the retainer (6) located on the rear of the right cylinder head.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the vent hose from the retainers (1,2) located on the transmission mount assembly.
  5. Support the transmission with a suitable jack.
  6. Remove the transmission mount assembly. Refer to Transmission Mount Replacement .
  7. Cut the tie straps (3,4) that secure the vent hose to the transmission wiring harness.
  8. Lower the transmission and remove the vent hose from the vent tube (5).
  9. Remove the vent hose assembly from the vehicle.
scientia non olet · About LEMON Manuals