LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 6L80E) >> Repair Instructions >> Vent Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Vent Hose Retainer
    GM1645250Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose assembly to the vehicle.
  2. Connect the vent hose to the vent tube (5).
  3. Raise the transmission to the installed position.
  4. Install new tie straps (3,4) to secure the vent hose to the transmission wiring harness. Do not collapse the vent hose while tightening the tie straps.
  5. Install the transmission mount assembly. Refer to Transmission Mount Replacement .
  6. Remove the jack.
  7. Install the vent hose to the retainers (1,2) located on the mount assembly.
  8. Lower the vehicle.
  9. Install the vent hose to the retainer (6) located on the rear of the right cylinder head.
    10. Fig 2: Air Inlet Housing Front Panel
    GM1644927Courtesy of GENERAL MOTORS CORP.
  10. Install the air inlet housing front panel (2). Refer to Air Inlet Housing Front Panel Replacement .
scientia non olet · About LEMON Manuals