LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 6L80E) >> Repair Instructions >> Transmission Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the transmission mount support assembly to the vehicle.
    2. Fig 1: Transmission Mount Support
    GM1649726Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the transmission mount support to transmission mounting bolts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

  3. Install the transmission mount support to body mounting bolts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

  4. Install the transmission vent hose to the retainers on the mount assembly.
  5. Remove the transmission jack.
  6. Install the exhaust system.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals