LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 6L80E) >> Repair Instructions >> Transmission Fluid Cooler Pipe Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the TOC lines.
    2. NOTE: Refer to Fastener Notice .
  2. Install the TOC retainer bracket bolt.

    Tighten:  Tighten the bolt to 16 N.m (12 lb ft).

    3. Fig 1: TOC Line To Transmission Retainer Bolt
    GM1710028Courtesy of GENERAL MOTORS CORP.
  3. Install new O-rings to the rear TOC lines.
  4. Connect the rear TOC lines to the transmission.
  5. Install the rear TOC line to transmission retainer bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  6. Connect the rear TOC line to the front TOC line.
  7. Connect the rear TOC line to the radiator.
  8. Install the LH front splash shield.
  9. Install the LH front splash shield retainers.
  10. Install the LH front wheel. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals