LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 6L80E) >> Repair Instructions >> Transmission Fluid Cooler Pipe Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the front TOC lines.
  2. Connect the front TOC line to the rear TOC line.
  3. Connect the front TOC line to the radiator.
    4. Fig 1: Cooling Fan Shroud
    GM1704897Courtesy of GENERAL MOTORS CORP.
  4. Connect the TOC lines to the transmission oil cooler.
  5. Reposition the radiator.
    6. Fig 2: View Of Radiator Support Brackets
    GM1334986Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  6. Install the bolts that secure the radiator support brackets.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  7. Install the bolts that secure the TOC line to the cooling fan shroud.

    Tighten:  Tighten the bolt to 6.5 N.m (58 lb in).

  8. Reposition and reinstall the condenser. Refer to Condenser Replacement (Heavy Duty Cooling) or Condenser Replacement (Standard Cooling) or Condenser Replacement (LC3) .
scientia non olet · About LEMON Manuals