LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 6L80E) >> Repair Instructions >> Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing J 41623-B Onto Generator Cooling Inlet Pipe
    GM1195053Courtesy of GENERAL MOTORS CORP.
  1. Install the J 41623-B  onto the transmission oil cooler (TOC) pipe. See Special Tools .
    2. Fig 2: Sliding J 41623-B Toward Generator Cooling Inlet Pipe Fitting
    GM1195054Courtesy of GENERAL MOTORS CORP.
  2. Slide the J 41623-B  toward the TOC pipe fitting. See Special Tools .
    3. Fig 3: Rotating J 41623-B On Coolant Pipe
    GM1195056Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Rotate the J 41623-B  to engage the TOC pipe fitting's retainer slots. See Special Tools .
    The J 41623-B  should be nearly flush with the fitting. See Special Tools .
  3. Connect the J 41623-B  onto the TOC pipe fitting. See Special Tools .
    4. Fig 4: Rotating J 41623-B Until Retainer Clip Rises Above Fitting Retainer Seat
    GM1195059Courtesy of GENERAL MOTORS CORP.
  4. Rotate the J 41623-B  until the retainer clip (1) rises above the fitting retainer seat. See Special Tools .
    5. Fig 5: Removing J 41623-B From Generator Cooling Inlet Pipe
    GM1195062Courtesy of GENERAL MOTORS CORP.
  5. Pull back on the TOC pipe to disengage the pipe from the TOC pipe fitting.
  6. Remove the J 41623-B  from the TOC pipe. See Special Tools .
scientia non olet · About LEMON Manuals