LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 6L80E) >> Repair Instructions >> Shift Control Linkage Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Manual Shift Shaft Nut
    GM1841192Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control linkage to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the manual shift shaft nut.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

    3. Fig 2: Shift Control Linkage Rod
    GM1848884Courtesy of GENERAL MOTORS CORP.
  3. Connect the shift control linkage rod to the shift control assembly.
  4. Install the nut to the shift control linkage rod.
  5. Adjust the shift control linkage. Refer to Shift Control Linkage Adjustment .
  6. Confirm correct shift linkage adjustment with a scan tool.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals