LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 6L80E) >> Diagnostic Information and Procedures >> Transmission Fluid Cooler Flushing and Flow Test (J 45096) >> Code Recording Procedure

Code Recording Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Setting Main Function Switch To CODE Position
    GM1212346Courtesy of GENERAL MOTORS CORP.
  1. Turn the main function switch to the CODE position.
    2. IMPORTANT:
    • If power is interrupted prior to the recording of the seven-character code, the code will be lost and the flow rate test will need to be repeated.
    • The flow test must run for a minimum of 8-10 seconds and be above 0.5 GPM for a code to be generated.
  2. Record TESTED flow rate, temperature, cycle and seven-character flow code information on repair order.
scientia non olet · About LEMON Manuals