LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 6L80E) >> Diagnostic Information and Procedures >> DTC P1825 or P1915 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the IMS connector at the control solenoid (w/body and TCM) valve assembly. Ignition ON. The scan tool IMS A/B/C/P parameter should display HI for all four signal circuits.
    • If a signal circuit displays LOW, the control solenoid (w/body and TCM) valve assembly is faulty.
  2. Connect a 3-amp fused jumper wire between each transmission range signal circuit at the control solenoid (w/body and TCM) valve assembly and ground ensuring that the signal circuit displays LOW when connected to ground.
    • If a signal circuit remains HI when connected to ground, the control solenoid (w/body and TCM) valve assembly is faulty.
    • If the above two tests indicate correct TCM functions, the IMS is faulty.
scientia non olet · About LEMON Manuals