Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.

Ensure the transmission fluid temperature is between 50-80°C (122-176°F).
Operate the vehicle in 4th, 5th, or 6th gear with TCC applied, long enough to ensure at least a 3°C (5°F) rise in TCM substrate temperature.
Observe the scan tool data parameter Shift Sol. 2 CKT Status. The parameter should display OK.
- If the parameter displays Open, Short to Volts, Short to GND, or if the DTC resets, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection .
- If no concerns are found during the inspection, replace the control solenoid (w/body and TCM) valve assembly.