LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 4.4L - Troubleshooting & Diagnosis) >> Service Bay Test >> Test Procedure

Test Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: If the Service Bay Test aborts or fails a DTC will NOT be set.
  1. Install a scan tool.
  2. Select the Service Bay Test with the scan tool.
    3. CAUTION: Refer to Road Test Caution .
  3. Follow the instructions on the scan tool.
    • If the test aborts, correct the condition for running the test and then retest.
    • If the test fails, repair the vehicle for the condition indicated by the failure message on the scan tool.
  4. Verify that the EVAP I/M system status is set to YES.
scientia non olet · About LEMON Manuals