LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 4.6L (LH2) - 1 Of 5) >> On-Vehicle Repair Instructions (Part 1) >> Water Pump and Air Conditioning Compressor and Power Steering Pump Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Air Conditioning, Power Steering & Water Pump Belt
    GM887836Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  3. If equipped with a crankshaft driven cooling fan, remove the cooling fan bracket. Refer to Engine Cooling Fan Bracket Replacement (LH2) .
  4. Rotate the drive belt tensioner (2) clockwise to release drive belt tension.
  5. Slide the drive belt from the water pump pulley (1).
  6. Slide the drive belt out from behind the drive belt tensioner. Access the belt from the side of the tensioner pulley in the location of the lower reservoir mounting nut.
  7. Allow the drive belt tensioner to return to the relaxed position.
  8. Remove the drive belt from the remaining pulleys.
scientia non olet · About LEMON Manuals