LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 4.6L (LH2) - 1 Of 5) >> On-Vehicle Repair Instructions (Part 1) >> Water Pump and Air Conditioning Compressor and Power Steering Pump Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Air Conditioning, Power Steering & Water Pump Belt
    GM887836Courtesy of GENERAL MOTORS CORP.
  1. Route the drive belt to the accessory drive pulleys, excluding the tensioner (2) and the water pump pulley (1).
  2. Rotate the drive belt tensioner (2) clockwise.
  3. Slide the drive belt behind the drive belt tensioner and around the tensioner pulley. Access the belt from the side of the tensioner pulley in the location of the lower reservoir mounting nut.
  4. Route the drive belt under the water pump pulley (1).
    5. IMPORTANT: Ensure the drive belt is properly aligned and seated into the grooves of the accessory drive pulleys.
  5. Release the drive belt tensioner and inspect the drive belt for proper seating in the accessory drive pulleys.
  6. If equipped with a crankshaft driven cooling fan, install the cooling fan bracket. Refer to Engine Cooling Fan Bracket Replacement (LH2) .
  7. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  8. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals