LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 4.6L (LH2) - 1 Of 5) >> On-Vehicle Repair Instructions (Part 1) >> Oil Pump Outlet Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the oil pump. Refer to Oil Pump Replacement .
    2. Fig 1: Identifying Primary Timing Gear Alignment Marks
    GM517185Courtesy of GENERAL MOTORS CORP.
  2. Align the primary timing marks (1) using the J 39946  .
  3. Remove the secondary camshaft drive chains. Refer to Secondary Camshaft Drive Chain Replacement - Right Side  and Secondary Camshaft Drive Chain Replacement - Left Side .
  4. Remove the primary drive chain tensioner. Refer to Primary Camshaft Drive Chain Tensioner Replacement .
    5. Fig 2: View Of Oil Outlet Tube Bolts
    GM928361Courtesy of GENERAL MOTORS CORP.
  5. Remove the oil outlet tube bolts (1-5).
  6. Remove the oil outlet tube.
    7. Fig 3: View Of Oil Outlet Tube O-Ring
    GM928363Courtesy of GENERAL MOTORS CORP.
  7. Remove and discard the oil outlet tube O-ring.
  8. Clean and inspect the oil outlet tube. Refer to Oil Pump Outlet Tube Cleaning and Inspection .
scientia non olet · About LEMON Manuals